One of the first steps you take when you are getting a good idea your gardening schedule is find your USDA Zone info. The most important data that the zone info tells us is average last frost and the lowest expected temperature for your area.

In Sebring you can figure out when to plant platycodon by using the USDA zone info.

Planting Calendar for Platycodon

Frost tolerance for platycodon:	Tolerant of a very small amount of frost.
When to plant:	Up to 3 weeks before last frost.

Platycodon do ok in moderate cold which means that you can get them planted just a bit earlier than other plants that might not handle the cold.

The earliest that you can plant platycodon in Sebring is February. However, you really should wait until March if you don't want to take any chances.

The last month that you can plant platycodon and expect a good harvest is probably September. Any later than that and your platycodon may not have a chance to grow to maturity. If you are starting your platycodon indoors then you might be able to get away with starting them a couple of weeks earlier.

Last Frost Date

In Sebring the average date of last frost happens on February 15. You should expect an average low temperature of 25°F in the coldest months of winter.

Just be sure to remember that the actual date of last frost is not always accurate because it is based on the USDA zone info for Sebring and it can change quite a bit from year to year. Half of the time in Sebring you get surprised by a frost after February 15 so make sure that you are prepared to cover your platycodon in the event of a late frost.

USDA Zone Info for Sebring

Here is the info for USDA Zone 9b.

Average Date of Last Frost (spring)	February 15
Average Date of First Frost (fall)	December 15
Lowest Expected Low	25°F
Highest Expected Low	30°F

This means that on a really cold year, the coldest it will get is 25°F. On most years you should be prepared to experience lows near 30°F.

Plants to Grow in Sebring

You may be interested in your other planting guides for Sebring.